Wedge Tool
Plate Spreader, Cam Puller, Gear Puller

Another Great New Tool Available From Checkingtime.com!

 

Available Now!

  • This is the most used tool in my shop!
  • Use this to spread one corner of a clock plate to separate the plate enough to remove one wheel at a time. Very handy for adjusting wheel timing in the strike train.
  • I also use them in pairs to remove stubborn gears and cams.
  • You will find many uses for this tool!
  • No other tool like it on the market.
  • Made in the USA!

 

 

Clock Repair Tools

Clock Repair Tools
  • Simply loosen the post nut, insert the "Wedge Tool" between the post and the plate and push in just enough to release the pivot your needing to adjust. There is no reason to pull the entire plate and reset all of those wheels again, only to find they STILL aren't right.
  • Saves you tons of time and you get the job done right.
  • Remember: Time IS Money!
These are really handy and when used in pairs, open up other uses. Double Cut Wedge- So it gets under very low clearances.